Westone 82-0101-W Instruction Manual download pdf (Page 9)

-9-

-12-

NOTE: The Tomato & Fruit Strainer Attachment cannot be used with meat products.

1. Hold the Plastic Chute with the outlet tilted almost fully downward and the head ring

facing the Motor Unit (gure 6).

2. Place the head ring over the round raised face on

the front of the Motor Unit. Position the tabs on the

head ring next to the slots in the corresponding tabs

extending from the round face (gure 7).

3. Rotate the Plastic Chute counterclockwise

until the tabs t into the slots. The Plastic Chute

should now be rmly held in place. When properly

positioned, the outlet of the Plastic Chute should

dip slightly downward.

4. Make sure the round end of the Drive Shaft

is equipped with a metal washer, spring and metal

washer (in this order). Install the Plastic Washer

onto the round end of the Drive Shaft (gure 8).

5. Insert the white end of the Drive Shaft into the

corresponding slot in the Auger.

6. Insert the Auger/Drive Shaft assembly into

the Grinder Head.

7. Position the Screen over the Auger. Line

up the tabs on the Screen with the notches in the

Grinder Head. Hold the Screen in place.

Figure 6

Stainless

Steel

Screen

Plastic

Auger

Grinder

Head

Motor

Unit

Tray

Stomper

Head

Locking

Knob

Plastic

Chute

Drive

Shaft

USING THE STUFFER

NOTE: Follow the “Food Safety Guidelines” in this

manual and as outlined by the U.S. Food and Drug

Administration (FDA) whenever using this appliance.

Keep meat/food refrigerated and covered. Do not

let meat/food sit out any longer than is necessary for

processing.

1. Place seasoned, ground meat in the Tray. Do

not overll the Tray. DO NOT operate the Grinder

without the Tray in place.

2. Twist or tie closed one end of the sausage

casing. You also can close and secure the end with

a hog ring.

3. Slide the open end of the casing onto the

Stufng Funnel until the entire casing is on the

Funnel.

4. Make sure the Motor Unit is turned “off.” Connect the

Motor Unit to an electrical outlet.

5. Turn the Motor Unit “on.”

6. Feed meat into the Grinder Head.

7. Use the Stomper to push meat into the Grinder. NEVER use your ngers!

8. Hold the sausage casing onto the Funnel so that it does not slip off while stufng.

9. Slowly release portions of the casing while stufng to allow the casing to ll with meat.

10. When stufng is complete, turn “off” the Motor Unit and disconnect it from the

electrical outlet.

11. Twist or tie closed each end of the casing. You also can close and secure the

ends with a hog ring.

HELPFUL HINT: Firmly press ground meat into the Grinder with the Stomper to

release any trapped air.

TOMATO & FRUIT STRAINER

ASSEMBLY Not included with all grinders.

Figure 7

Figure 8

Plastic

Chute

Round, raised face on

the front of Motor Unit

Tabs on

Motor Unit

Reverse

Button

Power

Switch

Outlet End

Head Ring

WARNING! Before cleaning, assembling or disassembling the Grinder, make sure

it is turned “off” and disconnected from the power source. Test to make sure there is

no power to the Grinder by switching the Motor Unit “on” and “off.”

Follow all of the Safety Rules

and Warnings in this manual

whenever using this appliance.

Never leave this

appliance unattended.

Disconnect from power supply

when not in use.

WARNING!

Keep ngers, hands,

other body parts and

foreign objects away

from the inlet during

operation!

Only use the provided

stomper to push food into

the appliance.

Keep children away!

Bushing

Set

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Westone 82-0101-W Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Mincers Westone 82-0101-W